Cisco ONS 15454 Troubleshooting Manual page 520

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3394 An error occurred while refreshing the power monitoring
values.
EID-3395 The configuration is invalid.
{0}
EID-3396 The configuration is invalid. The standby controller card is not
a TCC2P card.
EID-3397 The file {0} is the wrong version.
EID-3398 The PPM cannot be deleted.
EID-3399 The PPM cannot be deleted because it has port(s) in use.
EID-3400 Unable to switch. A force to the primary facility is not allowed. Refer to the error message text.
EID-3401 {0} cannot be provisioned for the port while {1} is enabled.
EID-3402 The switch request could not be completed.
The {0} card is not present or is not responding.
Try again after ensuring that the {0} card is present and is not
resetting.
EID-3403 The administrative state transition has not been attempted on
the monitored port.
EID-3404 The far end IP address could not be set on the {0} termination.
The IP address cannot be:
loopback (127.0.0.0/8)
class D (224.0.0.0/4)
class E (240.0.0.0/4)
broadcast (255.255.255.255/32)
internal {1}
EID-3405 You cannot change card parameters with port {0} in {1} state.
Click "Reset" to revert the changes.
EID-4000 The {0} ring name cannot be changed now because a {0}
switch is active.
EID-4001 The {0} node ID cannot be changed now because a {0} switch
is active.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-32
Chapter 4
Description
Refer to the error message text.
CTC encountered an error in IP address, net
mask length, or default router, or a
restricted IIOP port was selected.
The standby controller card should be a
TCC2P card.
The specified file is of wrong version.
Refer to the error message text.
Remove the ports connected to the
Pluggable Port Module before it can be
deleted.
The relationship between parameters {0}
and {1} are such that enabling either one,
prevents the provisioning of the other.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
You cannot change the ring name because a
switch of the same ring type is active.
You cannot change the ring ID because a
switch of the same ring type is active.
Error Messages
November 2009