Cisco ONS 15454 Troubleshooting Manual page 525

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-5057 The addition of the last node has not yet finished.
Please wait before trying to add a new node.
EID-5058 An OCHNC upgrade is applicable only to bidirectional circuits. Refer to the error message text.
EID-5059 The OCHNC upgrade failed.
One or more communication failures occurred during the
operation.
EID-5060 The OCHNC upgrade partially failed.
One or more communication failures occurred during the
operation.
Create the OCHCC manually.
EID-5061 The overhead circuit source and destination must reside on the
same shelf.
EID-5062 A four-fiber {0} cannot be created using three cards.
WID-5063 The profile "{0}" includes a change to the OPEN-SLOT alarm
severity.
This change is disallowed for the ONS 15600. "{1}" will
continue to use the OPEN-SLOT severity of MN that is
included in the default configuration.
Other changes from the "{2}" profile were successfully applied
to {3}".
EID-5064 {0}
{1}
WID-5065 If you apply routing constraints to more than {0} nodes,
performance might be affected and the operation might require
more time than expected.
Select Yes if you intend to proceed in spite of this risk, or No if
you prefer to review your selection.
WID-5066 The routing constraints will be lost.
Are you sure you want to reset your changes?
WID-5067 The routing constraints will be lost.
Are you sure you want to leave this panel?
EID-5068 The routing constraints could not be applied.
EID-5069 A source node cannot be added to either of these lists.
EID-5070 A destination node cannot be added to either of these lists.
EID-5071 This node already belongs to one of these lists.
EID-5072 An OCH-Trail tunnel link was found but without any associated
circuit.
EID-5073 You are creating an unprotected link from a protected port.
Do you want to continue?
November 2009
Description
Refer to the error message text.
CTC encountered a complete failure while
upgrading optical channel network
connection.
CTC encountered a partial failure while
upgrading an optical channel network
connection.
Refer to the error message text.
A four-fiber BLSR needs four cards.
Refer to the warning message text.
This indicates the status of path protection
switching.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
Select a node other than the source node to
add to the route.
Select a node other than the destination
node to add to the route.
The node is already selected either in
include or exclude list in the OCH circuit.
Create an OCH-Trail circuit associated with
the link.
Refer to the error message.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-37