Cisco ONS 15454 Troubleshooting Manual page 534

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-6146 Deleting the protection group while in a switched state might
cause a loss of traffic. It is recommended that you verify switch
states before proceeding.
EID-6147 The protection switch could not be performed.
EID-6148 A server trail is present.
EID-6149 The LAPD MTU size must be greater than or equal to the {0}
LSP buffer size {1}. Alternatively, you can decrease the {0}
LSP buffer size to {2}.
EID-6150 The value is out of range.
EID-6151 The minimum span loss must be less than the maximum span
loss.
EID-6152 The "Use NTP/SNTP Server" field is checked. Enter the
NTP/SNTP server IP address or server name.
EID-6153 The maximum frame size is invalid.
EID-6154 To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must be set
first.
EID-6155 Transponder mode cannot be provisioned with circuits on the
card.
EID-6156 The transponder configuration is invalid.
EID-6157 The watermark values are either out of range or inconsistent.
EID-6179 The 1+1 protection group is not optimized.
EID-6196 The equipment has failed or is missing.
EID-6197 Attributes cannot be changed when the port administrative state
is {0}.
WID-6204 This action will cause the node to reboot. When provisioning in
single-shelf mode, Shelf {0} of the node that you connect to
must be properly preprovisioned or you will lose traffic.
Use the LCD to return to single-shelf mode. CTC cannot be
used for this.
Changing from subtended shelf mode to single-shelf mode
could be traffic-affecting.
EID-6205 The interlink port is not provisioned.
EID-6206 The ADM peer group has already been created on the peer card. The user creates an ADM peer group
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-46
Chapter 4
Description
Refer to the warning message text.
A protection switch cannot be performed
during protection operations like manual
switch, lockout, and so on.
Refer to the warning message text.
Refer to the error message text.
Enter a value that is within the range.
Refer to the error message text.
Enter the NTP/SNTP server name. To leave
this field empty, uncheck the "Use
NTP/SNTP Server" and proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The transponder is not configured properly.
Enter valid watermark values.
Refer to the error message text.
Operation is requested on a failed or
missing equipment.
You cannot change the attributes when the
port is in the specified administrative state.
Refer to the warning message text.
The user creates an ADM peer group
without interlink ports.
involving an ADM card inserted in a peer
group.
Error Messages
November 2009