Figure 2-1 Shelf Lcd Panel - Cisco ONS 15454 Troubleshooting Manual

2.7.29 AUTONEG-RFI
Figure 2-1
If the temperature of the shelf exceeds 194 degrees F (90 degrees C), the alarm should clear if you solve
Step 2
the ONS 15454 temperature problem. Complete the
page
If the temperature of the shelf is under 194 degrees F (90 degrees C), the HITEMP alarm is not the cause
Step 3
of the AUTOLSROFF alarm. Complete the
for the OC-192 card.
If card replacement does not clear the alarm, call Cisco TAC 1 800 553-2447 to discuss the case and if
Step 4
necessary open a returned materials authorization (RMA) on the original OC-192 card.
2.7.29 AUTONEG-RFI
The autonegotiation remote fault indication (RFI) indicates that an ML1000 Gigabit Ethernet port cannot
detect its far-end link partner. This is typically caused by a far-end port shutdown or a unidirectional fiber
cut. The partner node is likely raising a CARLOSS alarm.
AUTONEG-RFI may also be caused by misconfigured autonegotiation parameters. This causes more of
a soft failure as opposed to the
typically caused by a failure like a loss of light or optical fiber. The alarm clears when the partner node
is detected.
The far end of an Ethernet link is usually a switch or router that does not use an ONS management
Note
system.
Clear the AUTONEG-RFI Alarm
Check for the
Step 1
MLFX)" alarm on page 2-65
procedure in this chapter.
If the alarm does not clear or if there is no far-end CARLOSS, check the near-end Gigabit Ethernet port
Step 2
autonegotiation settings:
a.
b.
c.
router# show interface gigabitethernet 0
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-50
Shelf LCD Panel
Slot Status
FAN FAIL CRIT MAJ
2-125.
Default Severity: Major (MJ), Service-Affecting (SA)
SONET Logical Object: ML1000
"CARLOSS (EQPT)" alarm on page 2-61
at the partner node. If the alarm exists there, follow the appropriate clearing
Double-click the ML1000 card to display the card view.
Click the upper IOS tab, then click Open IOS Connection.
In Privileged Executive mode, enter the following command:
Port
8/18/03
04.06-002L-10
MIN
"Clear the HITEMP Alarm" procedure on
"Physically Replace a Traffic Card" procedure on page 2-273
"CARLOSS (ML1000, ML100T, MLFX)" alarm on page
Chapter 2
24˚C
or the "CARLOSS (ML1000, ML100T,
Alarm Troubleshooting
2-65, which is
November 2009