Cisco ONS 15454 Troubleshooting Manual page 408

2.7.352 RPR-SF
•
Clear the RPR-SD Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447) to report a
Service-Affecting (SA) problem.
2.7.352 RPR-SF
The IEEE 802.17b-based RPR Signal Fail condition indicates a signal loss or major signal degradation
that deactivates the RPR-IEEE link. The failure that raises RPR-SF can be attributable to any of the
following alarms:
•
•
•
•
•
•
•
•
•
The RPR-SF condition can also occur if a SONET circuit's state is UNASSIGNED (not provisioned).
This condition clears when these primary cause alarms are cleared. RPR-SF is suppressed by the
"RPR-PASSTHR" alarm on page 2-209
suppresses the following alarms:
•
•
•
Clear the RPR-SF Condition
Complete the trouble-clearing procedure in this chapter for any primary cause SONET failure condition
Step 1
as previously listed.
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-214
RPR-SF, page 214
"Clear the SD-P Condition" procedure on page 2-221
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: ML100T, ML1000, MLFX
AIS-P, page 37
GFP-LFD, page 119
LOP-P, page 155
PDI-P, page 193
PLM-P, page 195
RFI-P, page 205
TIM-P, page 245
UNEQ-P, page 252
VCG-DOWN, page 256
MAN-REQ, page 178
RPR-SD, page 213
WTR, page 258
or the "FORCED-REQ" alarm on page
Chapter 2 Alarm Troubleshooting
to clear this secondary condition.
2-112. RPR-SF itself
November 2009