Cisco ONS 15454 Troubleshooting Manual page 261

Chapter 2 Alarm Troubleshooting
Clear the CLDRESTART Condition
Complete the
Step 1
page
If the condition fails to clear after the card reboots, complete the
Step 2
Card" procedure on page
If the condition does not clear, complete the
Step 3
page 2-273
If the condition does not clear, log into the Technical Support Website at
Step 4
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.61 COMIOXC
The Input/Output Slot To Cross-Connect Communication Failure alarm is caused by the XC10G or
XC-VXC-10G cross-connect card when there is a communication failure for a traffic slot.
Clear the COMIOXC Alarm
Complete the
Step 1
reported. For the LED behavior, see the
on page
Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green
Step 2
ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.
Step 3 If the CTC reset does not clear the alarm, move traffic off the reporting cross-connect card. Complete
the
Step 4 Complete the
the alarm is reported.
If the alarm does not clear, complete the
Step 5
procedure on page 2-274
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 6
for more information or call Cisco TAC 1 800 553-2447 in order to report a Service-Affecting (SA)
problem.
2.7.62 COMM-FAIL
November 2009
"Remove and Reinsert (Reseat) the Standby TCC2/TCC2P Card" procedure on
2-272.
2-273.
for the card.
Default Severity: Critical (CR), Service-Affecting (SA)
SONET Logical Object: EQPT
"Reset a Traffic Card in CTC" procedure on page 2-270
2-260.
"Side Switch the Active and Standby Cross-Connect Cards" procedure on page
"Remove and Reinsert (Reseat) Any Card" procedure on page 2-273
for the reporting cross-connect card.
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
"Physically Replace a Traffic Card" procedure on
"2.8.2 Typical Traffic Card LED Activity During Reset" section
"Physically Replace an In-Service Cross-Connect Card"
Cisco ONS 15454 Troubleshooting Guide, R8.5
2.7.61 COMIOXC
"Remove and Reinsert (Reseat) Any
on the card in which the alarm is
2-271.
on the card in which
2-67