Cisco ONS 15454 Troubleshooting Manual page 517

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3315 This operation cannot be performed.
EID-3316 The node side is invalid.
EID-3317 The ring name is too long.
EID-3318 The ring name is invalid.
EID-3319 The wrong line was selected.
EID-3320 The optical link could not be deleted.
EID-3321 This feature is unsupported by this version of software.
EID-3322 The equipment is not plugged in.
EID-3323 The APC system is busy.
EID-3324 There is no path to regulate.
EID-3325 The requested action is not allowed.
EID-3326 The input was invalid.
EID-3327 An error occurred while retrieving thresholds.
EID-3328 An error occurred while applying changes to row {0}.
The value is out of range.
EID-3330 Unable to switch to the byte because an overhead channel is
present on this byte of the port.
EID-3331 An error occurred while applying changes to the row.
EID-3334 Timing parameters on the protect port cannot be changed.
EID-3335 The port type cannot be changed because the SDH validation
check failed. Check if this port is part of a circuit, protection
group, SONET DCC, orderwire, or UNI-C interface.
EID-3336 An error occurred while reading a control mode value.
EID-3337 An error occurred while setting a set point gain value.
EID-3338 An error occurred while reading a set-point gain value.
EID-3339 An error occurred while setting a tilt calibration value.
EID-3340 An error occurred while setting expected wavelength.
EID-3341 An error occurred while reading expected wavelength.
EID-3342 An error occurred while reading actual wavelength.
EID-3343 An error occurred while reading actual band.
EID-3344 An error occurred while reading expected band.
November 2009
Description
CTC is unable to perform operation.
This task was applied to the wrong node
side.
Reduce the number of characters in the
name.
The name you entered is illegal.
Select another line
CTC cannot delete the optical link.
Refer to the error message text.
Plug-in the equipment and proceed.
Automatic Power Control (APC) system is
busy.
There is no circuit path to regulate.
Generic DWDM provisioning failure
message.
The input value is incorrect.
There was an error retrieving the thresholds.
This message is displayed only for the
OSCM/OSC-CSM line thresholds.
There was an error applying the changes to
the specified row. The value is out of range.
Refer to the error message text.
Refer to the error message text.
You cannot change timing parameters on
protect port.
Refer to the error message text.
The Control Mode must be retrieved.
The Gain Set Point must be set.
The Gain Set Point must be retrieved.
The tilt calibration must be set.
The expected wavelength must be set.
The expected wavelength must be retrieved.
The actual wavelength must be retrieved.
The actual band must be retrieved.
The expected band must be retrieved.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-29