Cisco ONS 15454 Troubleshooting Manual page 533

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-6121 This internal patchcord cannot be provisioned because the
endpoints have no compatible wavelengths.
EID-6122 The wizard could not be started.
{0}
EID-6123 The OSI request can not be completed successfully.
EID-6124 The ALS recovery pulse interval is invalid.
EID-6125 The ALS recovery pulse duration is invalid.
EID-6126 The current setting does not support the specified ALS mode.
EID-6127 All enabled routers are required to have the same area.
EID-6128 A software download is in progress. Configuration changes that
result in a card reboot cannot take place during a software
download.
Please try again after the software download is done.
EID-6129 The payload configuration and card mode are incompatible.
EID-6135 A DCC is present.
EID-6136 An error occurred during provisioning: {0}
EID-6137 Multishelf cannot be disabled.
{0}
EID-6138 The LAN configuration is invalid.
EID-6139 Invalid card(s) are present.
Please remove all non-MSTP cards and try again.
EID-6140 The shelf identifier for a subtended shelf cannot be provisioned
through CTC. It must be changed using the LCD.
EID-6143 The DHCP server could not be changed.
EID-6144 The port provisioning cannot be changed when the port media
is Undefined.
WID-6145 OSPF on LAN should only be enabled when the LAN routers
run OSPF. Otherwise, the node will not be reachable from
outside its subnet.
RIP implementation only advertise routes in one direction to
connected routers. It does not learn or distribute routes
advertised by other routers.
Also note that enabling OSPF on the LAN will temporarily
cause the current list of static routes to stop being advertised to
remote nodes and only be used locally.
November 2009
Description
The end points of an internal patchcord
should have compatible wavelengths.
CTC was unable to initiate the wizard due
to the specified reason.
A communication failure occurred.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
A data communication channel (DCC)
already exists.
CTC was not able to provision the specified
port or card.
Multishelf is not supported on equipment, is
already disabled, or modules on the shelf
are currently in use.
Verify the LAN configuration.
Non-DWDM cards cannot be added to an a
DWDM node. Remove the cards.
Refer to the error message text.
Refer to the error message text.
If the port is not pre-provisioned with the
type of media that is going to be inserted,
you cannot access any of the existing values
for the port.
Refer to the warning message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-45