Cisco ONS 15454 Troubleshooting Manual page 519

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3376 The measured span loss could not be retrieved.
EID-3377 The wrong interface was used.
EID-3378 This is a duplicate origination patchcord identifier.
EID-3379 This is a duplicate termination patchcord identifier.
EID-3380 The host cannot be found.
EID-3381 The maximum frame size must be between {0} and {1} and
may be increased in increments of {2}.
EID-3382 The number of credits must be between {0} and {1}.
EID-3383 The GFP buffers available must be between {0} and {1} and
may be increased in increments of {2}.
WID-3384 You are about to force the use of Secure Mode for this chassis.
You will not be able to undo this operation.
Is it OK to continue?
EID-3385 {0}. Delete the circuits and try again.
EID-3386 The transponder mode could not be provisioned:
{0}
EID-3387 You must change port(s) {0} to an out-of-service state before
changing card parameters. Click "Reset" to revert the changes.
EID-3388 The card mode cannot be changed because the card has circuits. Refer to the error message text.
EID-3389 An error occurred while changing the card mode.
EID-3390 The port is in use.
EID-3391 The port rate cannot be changed because the port has been
deleted.
WID-3392 The timing reference(s) could not be assigned because with
external timing, only a single protected, or two unprotected
timing references per BITS Out can be selected.
Please use the "Reset" button and verify the settings.
WID-3393 The timing reference(s) could not be assigned because with line
or mixed timing, only a single unprotected timing reference per
BITS Out can be selected.
Please use the "Reset" button and verify the settings.
November 2009
Description
Refer to the error message text.
The interface used for the card is wrong.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the origination node.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the remote node.
Refer to the error message text.
The frame size must be in the specified
range. It can increment by the specified
value.
The number of credits must be between the
specified values.
The GFP buffers must be in the specified
range. It can increment by the specified
value.
Refer to the warning message text.
Refer to the error message text.
The specified transponder mode cannot be
provisioned.
All the card ports should be changed to
out-of-service before changing the
parameters.
Refer to the error message text.
Refer to the error message text.
You cannot change the port rate of a card
that has been deleted.
Refer to the warning message text.
Refer to the warning message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-31