Cisco ONS 15454 Troubleshooting Manual page 262

2.7.63 CONTBUS-A-18
The Plug-In Module (card) Communication Failure indicates that there is a communication failure
between the TCC2/TCC2P and the traffic card. The failure could indicate a broken card interface.
Clear the COMM-FAIL Alarm
Complete the
Step 1
Step 2 If the alarm does not clear, complete the
for the card.
If the condition does not clear, log into the Technical Support Website at
Step 3
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.63 CONTBUS-A-18
A Communication Failure from Controller Slot to Controller Slot alarm for the TCC2/TCC2P slot to
TCC2/TCC2P slot occurs when the main processor on the TCC2/TCC2P in the first slot (TCC A) loses
communication with the coprocessor on the same card. This applies to the TCC2/TCC2P in Slot 7.
Clear the CONTBUS-A-18 Alarm
Complete the
Step 1
to make the TCC2/TCC2P in Slot 11 active.
Wait approximately 10 minutes for the TCC2/TCC2P in Slot 7 to reset as the standby TCC2/TCC2P.
Step 2
Verify that the ACT/SBY LED is correctly illuminated before proceeding to the next step. A green
ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.
Step 3 Position the cursor over the TCC2/TCC2P in Slot 11 and complete the
Card and Activate the Standby Card" procedure on page 2-270
If the reset card has not rebooted successfully, or the alarm has not cleared, call Cisco TAC
Step 4
(1-800-553-2447). If the Cisco TAC technician tells you to reseat the card, complete the
TCC2/TCC2P Card and Activate the Standby Card" procedure on page
technician tells you to remove the card and reinstall a new one, follow the
Card" procedure on page
2.7.64 CONTBUS-B-18
A Communication Failure from Controller Slot to Controller Slot alarm for the TCC2/TCC2P slot to
TCC2/TCC2P slot occurs when the main processor on the TCC2/TCC2P in the second slot (TCC B)
loses communication with the coprocessor on the same card. This applies to the Slot 11 TCC2/TCC2P.
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-68
"Reset a Traffic Card in CTC" procedure on page 2-270
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
"Remove and Reinsert (Reseat) the Standby TCC2/TCC2P Card" procedure on page 2-272
2-273.
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
"Physically Replace a Traffic Card" procedure on page 2-273
to return the card to the active state.
Chapter 2 Alarm Troubleshooting
for the reporting card.
"Reset an Active TCC2/TCC2P
"Reset an Active
2-270. If the Cisco TAC
"Physically Replace a Traffic
November 2009