Cisco ONS 15454 Troubleshooting Manual page 249

Chapter 2 Alarm Troubleshooting
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.38 AUTOSW-UNEQ (VT-MON)
AUTOSW-UNEQ (VT-MON) indicates that the
protection switching to occur. If the path protection is configured for revertive switching, it reverts to the
working path after the fault clears.
This condition is only reported if the path protection is set up for revertive switching.
Note
Clear the AUTOSW-UNEQ (VT-MON) Condition
Complete the
Step 1
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 2
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.
2.7.39 AWG-DEG
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.40 AWG-FAIL
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.41 AWG-OVERTEMP
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.42 AWG-WARM-UP
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
November 2009
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: VT-MON
"Clear the UNEQ-V Alarm" procedure on page
2.7.38 AUTOSW-UNEQ (VT-MON)
"UNEQ-V" alarm on page 2-254
2-254.
Cisco ONS 15454 Troubleshooting Guide, R8.5
caused automatic path
2-55