Cisco ONS 15454 Troubleshooting Manual page 241

Chapter 2 Alarm Troubleshooting
•
•
Determine whether alarms are suppressed for a port and if so, raise the suppressed alarms:
Step 3
a.
b.
If the AS-CMD condition is reported for a card and not an individual port, in node view click the
Step 4
Provisioning > Alarm Profiles > Alarm Behavior tabs.
Step 5 Locate the row number for the reported card slot.
Step 6 Click the Suppress Alarms column check box to deselect the option for the card row.
Step 7 If the condition is reported for the backplane, the alarms are suppressed for cards such as the ONS 15454
AIP that are not in the optical or electrical slots. To clear the alarm, complete the following steps:
a.
b.
c.
If the condition is reported for the shelf, cards and other equipment are affected. To clear the alarm,
Step 8
complete the following steps:
a.
b.
c.
Step 9 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.24 AS-MT
The Alarms Suppressed for Maintenance Command condition applies to OC-N and electrical cards and
occurs when a port is placed in the Out-of-Service and Management, Maintenance (OOS-MA,MT)
service state for loopback testing operations.
November 2009
If the condition is reported against the backplane, go to
If the condition is reported against the NE object, go to
Double-click the card to open the card view.
Click the Provisioning > Alarm Profiles > Alarm Behavior tabs and complete one of the following
substeps:
If the Suppress Alarms column check box is checked for a port row, deselect it and click Apply.
•
If the Suppress Alarms column check box is not checked for a port row, from the View menu
•
choose Go to Previous View.
In node view, click the Provisioning > Alarm Profiles > Alarm Behavior tabs.
In the backplane row, uncheck the Suppress Alarms column check box.
Click Apply.
In node view, click the Provisioning > Alarm Profiles > Alarm Behavior tabs if you have not
already done so.
Click the Suppress Alarms check box located at the bottom of the window to deselect the option.
Click Apply.
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: CEMR, CE1000, CE100T, DS1, DS3, E1, EC1, EQPT, FCMR, G1000,
GFP-FAC, ML1000, ML100T, MLFX, OCN
DWDM Logical Objects: 2R, AOTS, ESCON, FC, GE, ISC, OCH, OMS, OTS, PPM, SHELF,
TRUNK
Step 7.
Step 8.
Cisco ONS 15454 Troubleshooting Guide, R8.5
2.7.24 AS-MT
2-47