Cisco ONS 15454 Troubleshooting Manual page 509

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3122 No object of type {0} was selected to edit.
EID-3123 An error occurred while editing {0}.
EID-3124 The {0} termination is in use.
Delete the associated OSPF range table entry and try again.
EID-3125 No {0} terminations were selected.
EID-3126 The {0} termination could not be edited.
EID-3127 Orderwire cannot be provisioned because the E2 byte is in use
by {0}.
EID-3128 The authentication key cannot exceed {0} characters.
EID-3129 The authentication keys do not match!
EID-3130 An error occurred while creating the OSPF area virtual link.
EID-3131 An error occurred while creating the OSPF virtual link.
EID-3132 An error occurred while setting the OSPF area range: {0}, {1},
false.
EID-3133 The maximum number of OSPF area ranges has been exceeded. OSPF area ranges exceeded the maximum
EID-3134 The area ID is invalid. Use the DCC OSPF area ID, LAN port
area ID, or 0.0.0.0.
EID-3135 The mask is invalid.
EID-3136 The range address is invalid.
EID-3137 Your request has been denied because the timing source
information was updated while your changes were still
pending. Please retry.
EID-3138 The clock source for switching is invalid.
EID-3139 A switch cannot be made to a reference of inferior quality.
EID-3140 A higher priority switch is already active.
EID-3141 An attempt was made to access a bad reference.
EID-3142 No switch is active.
EID-3143 An error occurred while creating the static route entry.
EID-3144 The maximum number of static routes has been exceeded.
November 2009
Description
Choose an object of the specified type to
edit.
There was an error editing the item.
Refer to the error message text.
No specified terminations are selected.
CTC could not edit the specified
termination.
Refer to the error message text.
The authentication key cannot exceed the
specified number of characters.
Refer to the error message text.
CTC encountered an error while creating
the area virtual link.
CTC encountered an error creating the
virtual link.
CTC encountered an error while setting the
area range for the specified values.
number.
Refer to the error message text.
Refer to the error message text.
The range address is invalid. Try again.
Refer to the error message text.
You have selected an invalid clock source.
Choose another clock.
Refer to the error message text.
You cannot switch the timing source
manually when a higher priority switch is
already active.
Refer to the error message text.
None of the switches are active.
CTC encountered an error while a creating
static route entry.
The number of static routes has exceeded its
limit.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-21