Cisco ONS 15454 Troubleshooting Manual page 514

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3254 An error occurred during validation. {0}
EID-3255 You cannot change the timing configuration because a
Manual/Force operation is in effect.
WID-3256 The timing reference(s) could not be assigned because one or
more of the timing reference(s):
- is already used and/or
- has been selected twice and/or
- is attempting to use the same slot twice.
Please verify the settings.
EID-3257 Duplicate DCC numbers are not permitted. {0}.
EID-3258 A software error occurred while attempting to download the
file.
Please try again later.
EID-3259 An error occurred while creating the FC-MR threshold.
EID-3260 An error occurred while provisioning the internal subnet:
{0}
EID-3261 The port rate provisioning cannot be changed while circuits
exist on this port.
EID-3262 The port provisioning cannot be changed when the port status
is {0}.
WID-3263 You are using Java version {0}. CTC should run with Java
version {1}. It can be obtained from the installation CD or
http://java.sun.com/j2se/
EID-3265 An error occurred while modifying the protection group.
EID-3266 Conditions could not be retrieved from the shelf or card view.
WID-3267 The XTC protection group cannot be modified.
WID-3268 The filter entry is invalid. {0}
WID-3269 The {0} operation was successfully initiated for {1} but its
completion status could not be obtained from the node. When
the node is accessible, check its software version to verify if the
{0} succeeded.
WID-3270 The file {0} does not exist.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-26
Chapter 4
Description
The Cisco Transport Controller (CTC) was
unable to validate the values entered by the
user, specified by {0}. This error message is
common to several different provisioning
tabs within the CTC.
Refer to the error message text.
Refer to the warning message text.
CTC detected more than one occurrence of
the a DCC number. Remove one of them.
Refer to the error message text.
You must create a Fibre Channel Multirate
(FC_MR) card threshold.
The specified internal subnet could not be
provisioned.
Refer to the error message text.
You must provision the ports only when the
port is Out of Service.
CTC is being launched with the wrong
version of the JRE {0}. This version of CTC
requires a particular version of the JRE {1}.
The CTC and browser must be closed and
restarted to allow the correct Java version to
be loaded.
Protection Group could not be modified.
Refer to the error message text.
Refer to the warning message text.
The specified entry is invalid.
Refer to the error message text.
The specified file does not exist.
Error Messages
November 2009