Cisco ONS 15454 Troubleshooting Manual page 69

Chapter 1 General Troubleshooting
Create the Terminal Loopback on a Destination DS-3E or DS3XM Port
Connect an electrical test set to the port you are testing:
Step 1
a.
b.
c.
Step 2 In CTC node view, click the Circuits tab and click Create.
In the Circuit Creation dialog box, choose the type, such as STS, and number, such as 1.
Step 3
Click Next.
Step 4
In the next Circuit Creation dialog box, give the circuit an easily identifiable name such as DS1toDS3.
Step 5
Leave the Bidirectional check box checked.
Step 6
Click Next.
Step 7
In the Circuit Creation source dialog box, select the Node, card Slot, Port, and STS (or VT) where the
Step 8
test set is connected.
Click Next.
Step 9
In the Circuit Creation destination dialog box, use the same Node, card Slot, Port, and STS (or VT) used
Step 10
for the source dialog box.
Click Next.
Step 11
In the Circuit Creation circuit routing preferences dialog box, leave all defaults. Click Finish.
Step 12
Confirm that the newly created circuit appears in the Dir column as a two-way circuit.
Step 13
Note
Note
Create the terminal loopback on the destination port being tested:
Step 14
a.
b.
c.
November 2009
If you just completed the "1.2.3 Perform an XC Loopback on a Destination-Node OC-N STS (West
to East) Carrying an Electrical Signal" procedure on page
up to the electrical port in the source node.
If you are starting the current procedure without the electrical test set hooked up to the electrical
port, use appropriate cabling to attach the Tx and Rx terminals of the electrical test set to the DSx
panel or the EIA connectors for the port you are testing. Both Tx and Rx connect to the same port.
Adjust the test set accordingly. (Refer to manufacturer instructions for test-set use.)
It is normal for the "LPBKTERMINAL (DS1, DS3)" condition on page 2-174
a loopback setup. The condition clears when you remove the loopback.
ONS 15454 DS-3 terminal loopbacks do not transmit an AIS in the direction away from the
loopback. Instead of AIS, a continuance of the signal transmitted into the loopback is provided.
A DS3/EC1-48 card can be provisioned to transmit AIS for a terminal loopback if desired.
Go to the node view of the destination node:
Choose View > Go To Other Node from the menu bar.
•
Choose the node from the drop-down list in the Select Node dialog box and click OK.
•
In node view, double-click the card that requires the loopback, such as the DS-N card in the
destination node.
Click the Maintenance > DS3 tabs.
1.2.4 Perform a Terminal Loopback on a Destination Electrical Port (West to East)
Cisco ONS 15454 Troubleshooting Guide, R8.5
1-18, leave the electrical test set hooked
to appear during
1-25