Cisco ONS 15454 Troubleshooting Manual page 282

2.7.92 ERFI-P-PAYLD
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.92 ERFI-P-PAYLD
The Three-Bit ERFI Path Payload condition is triggered on DS-1, DS-3, or VT circuits when the
"PLM-P" alarm on page 2-195
Clear the ERFI-P-PAYLD Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.93 ERFI-P-SRVR
The Three-Bit ERFI Path Server condition is triggered on DS-1, DS-3, or VT circuits when the
condition on page 2-37
Clear the ERFI-P-SRVR Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.94 ERROR-CONFIG
The Error in Startup Configuration alarm applies to the ML-Series Ethernet cards. These cards process
startup configuration files line by line. If one or more lines cannot be executed, the error causes the
ERROR-CONFIG alarm. ERROR-CONFIG is not caused by hardware failure.
The typical reasons for an errored startup file are:
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-88
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, STSTRM
"Clear the PLM-P Alarm" procedure on page
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, STSTRM
or the
"Clear the LOP-P Alarm" procedure on page
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
is raised on the transmission signal.
"LOP-P" alarm on page 2-155
Chapter 2 Alarm Troubleshooting
2-196. This should clear the ERFI condition.
is raised on the transmission signal.
2-155. This should clear the ERFI condition.
"AIS-P"
November 2009