Cisco ONS 15454 Troubleshooting Manual page 384

2.7.295 ODUK-OCI-PM
2.7.295 ODUK-OCI-PM
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.296 ODUK-SD-PM
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.297 ODUK-SF-PM
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.298 ODUK-TIM-PM
For information about this alarm or condition, refer to the "Alarm Troubleshooting" chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.299 OOU-TPT
The Out of Use Transport Failure alarm is a VCAT member alarm. (VCAT member circuits are
independent circuits that are concatenated from different time slots into a higher-rate signal.) This
condition is raised when a member circuit in a VCAT is unused, such as when it is removed by
SW-LCAS. It occurs in conjunction with the
Clear the OOT-TPT Condition
Complete the
Step 1
this condition as well.
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC 1 800 553-2447.
2.7.300 OPEN-SLOT
Cisco ONS 15454 Troubleshooting Guide, R8.5
2-190
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
"Clear the VCG-DEG Condition" procedure on page
Default Severity: Not Alarmed (NA)
Logical Object: EQPT
"VCG-DEG" condition on page
2-256. Clearing that condition clears
Chapter 2 Alarm Troubleshooting
2-255.
November 2009