Cisco ONS 15454 Troubleshooting Manual page 486

3.3.23 LOGIN-FAIL-LOCKOUT
3.3.23 LOGIN-FAIL-LOCKOUT
The Invalid Login–Locked Out (LOGIN-FAIL-LOCKOUT) condition occurs when you attempt to log
into a locked account.
This transient condition does not result in a standing condition.
3.3.24 LOGIN-FAIL-ONALRDY
The Security: Invalid Login–Already Logged On (LOGIN-FAIL-ONALRDY) condition occurs when
you attempt to login to a node where the user already has an existing session and a Single-User-Per-Node
(SUPN) policy exists.
This transient condition does not result in a standing condition.
3.3.25 LOGIN-FAILURE-PSWD
The Invalid Login–Password (LOGIN-FAILURE-PSWD) condition occurs when you attempt to login
with an invalid password.
This transient condition does not result in a standing condition.
3.3.26 LOGOUT-IDLE-USER
The Automatic Logout of Idle User (LOGOUT-IDLE-USER) condition occurs when a user session is
idle for too long (the idle timeout expires) and the session terminates as a result. You must log in again
to restart your session.
3.3.27 MANWKSWBK-NO-TRFSW
The Manual Switch Back To Working Resulted in No Traffic Switch (MANWKSWBK-NO-TRFSW)
condition occurs when you perform a Manual switch to the working port/card and the working port/ card
is already active.
This transient condition does not result in a standing condition.
3.3.28 MANWKSWPR-NO-TRFSW
The Manual Switch to Protect Resulted in No Traffic Switch (MANWKSWPR-NO-TRFSW) condition
occurs when you perform a Manual switch to the protect port/card and the protect port/card is already
active.
This transient condition results in a BLSR Manual Switch (Span or Ring) standing condition.
3.3.29 PM-TCA
The Performance Monitor Threshold Crossing Alert (PM-TCA) condition occurs when network
collisions cross the rising threshold for the first time.
Cisco ONS 15454 Troubleshooting Guide, R8.5
3-8
Chapter 3 Transient Conditions
November 2009