Cisco ONS 15454 Troubleshooting Manual page 495

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2059 An error occurred while deleting the node.
{0}
EID-2060 No PCA circuits were found.
EID-2061 An error occurred while provisioning the VLAN.
EID-2062 An error occurred while deleting VLANs.
No VLAN(s) were selected.
Please select a VLAN.
EID-2063 The default VLAN cannot be deleted.
EID-2064 An error occurred while deleting VLANs.
{0}
EID-2065 The profile cannot be imported.
The profile "{0}" exists in the editor and the maximum number
of copies (ten) exists in the editor.
The import will be aborted. The profile has already been loaded
eleven times.
EID-2066 The profile could not be stored.
An error occurred while writing to {0}.
EID-2067 An error occurred while writing to the file.
{0}
EID-2068 The alarm profile could not be loaded from the node.
EID-2069 The file could not be found or an I/O exception occurred.
{0}
EID-2070 The profile could not be deleted.
{0}
EID-2071 Only one column may be highlighted.
EID-2072 Only one profile may be highlighted.
EID-2073 This column is permanent and cannot be removed.
EID-2074 Select one or more profiles.
EID-2075 This column is permanent and cannot be reset.
EID-2077 This column is permanent and cannot be renamed.
EID-2078 At least two columns must be highlighted.
November 2009
Description
There was an error during the node deletion.
CTC could not find any protection channel
access (PCA) circuits for this task.
There was an error defining the VLAN.
Refer to the error message text.
The selected VLAN is the default VLAN
and cannot be deleted.
There was an error deleting the specified
VLAN.
Cannot import the profile because the
profile has reached the maximum number of
copies in the editor.
CTC encountered an error while trying to
store the profile.
CTC encountered an error while writing the
specified file.
CTC encountered an error trying to load the
alarm profile from the node.
Either the specified file was not found, or
there was an input/output exception.
There was a failure in deleting the specified
profile.
You cannot select more than one column
during clone action.
You cannot select more than one profile.
You cannot delete a permanent column.
You have not selected any profile or
column. Reset operation is done by
right-clicking the selected column.
Refer to the error message text.
Refer to the error message text.
You cannot compare two profiles unless you
select two columns.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-7