Cisco ONS 15454 Troubleshooting Manual page 518

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3345 An error occurred while setting expected band.
EID-3346 An error occurred while retrieving defaults from the node: {0}. There was an error retrieving defaults from
EID-3347 The file {0} cannot be loaded.
EID-3348 Properties cannot be loaded from the node.
EID-3349 NE update properties cannot be saved to a file.
EID-3350 NE update properties cannot be loaded from the node.
EID-3351 The file {0} does not exist.
EID-3352 An error occurred while setting a value at {0}.
EID-3353 No such interface is available.
EID-3354 The specified endpoint is in use.
EID-3355 The specified endpoint is incompatible.
EID-3357 The connections could not be calculated.
EID-3358 An optical link model does not exist for the specified interface. Create an optical linkmodel for the
EID-3359 Optical parameters could not be set for the node.
EID-3360 ANS cannot be performed.
Please check {0} parameter value.
EID-3361 The ring termination is in use.
An error occurred while deleting the ring termination.
EID-3362 An error occurred while deleting the ring termination.
EID-3363 No ring terminations were selected.
EID-3364 An error occurred while creating the ring ID.
EID-3365 The OSC termination is in use.
EID-3366 The OSC termination could not be deleted.
EID-3370 No optical link was selected.
EID-3371 An error occurred while calculating the automatic optical link
list.
EID-3372 CTC attempted to access an OCHNC connection that has been
destroyed.
EID-3375 The expected span loss must be set.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-30
Chapter 4
Description
The expected band must be set.
the specified node.
CTC cannot load the specified file.
Refer to the error message text.
Check your file system for space constraint
or any other problem.
Refer to the error message text.
The specified file does not exist.
There was an error while setting the value at
the specified location.
The interface specified is not present in
CTC.
Select another endpoint that is not in use.
Refer to the error message text.
Refer to the error message text.
interface, and proceed.
Refer to the error message text.
Refer to the error message text.
You cannot delete a ring in use.
There was an error while deleting ring
termination.
You must select a ring termination.
There was an error while creating the ring
ID.
Select another optical service channel
(OSC) which is not in use.
There was an error deleting the OSC
termination.
You must select an optical link.
Refer to the error message text.
CTC destroyed an external attempt to
access an optical channel network
connection.
Refer to the error message text.
Error Messages
November 2009