Cisco ONS 15454 Troubleshooting Manual page 535

Hide thumbs Also See for ONS 15454:
Table of Contents

Advertisement

Chapter 4
Error Messages
Table 4-1
Error Messages (continued)
Error Warning
ID
Error Warning Message
EID-6207
This card is not in the ADM peer group.
EID-6208
The payload is not OTU2.
EID-6209
The side is already defined by the node.
EID-6210
No side was selected.
EID-6211
The side was not deleted.
EID-6212
One of the ports is connected to a patchcord or virtual link.
EID-6213
It is not possible to associate the side to the two ports.
EID-6214
The port is already assigned to a side.
EID-6215
Error provisioning the CVLAN ID.
Enter a valid number or range between 0 and 4094.
EID-6216
Changing card will reset the optical thresholds to the default
setting and may affect the optical connection.
The optical connection will work only if the optical
performance is compatible with {0} card.
Please check the network design.
EID-6217
You cannot delete the {0} {1}.
EID-6218
Invalid ethernet duplex value
EID-6219
Invalid committed info rate
EID-6220
Invalid mode value
EID-6221
Invalid mtu value
EID-6222
Invalid flow control value
EID-6223
Invalid Network Interface Mode
EID-6224
Invalid ingress COS value
EID-6225
Invalid ethertype value
November 2009
Description
The selected ADM card is not involved in
an ADM peer group.
Refer to the error message text.
During the creation of a side on node, a side
is already defined.
The user requests an operation on a side, but
no side is selected.
CTC could not delete the selected side
successfully.
An operation on a port was not performed
because the port is connected to a patchcord
or a virtual link.
During the creation of a side it is not
possible to associate the selected ports to
the new side.
The selected port is already assigned to a
side.
The entered CVLAN ID was out of the
admitted range.
Refer to the error message text.
You cannot delete {0} {1} because it is part
of an ADM peer group or one or more
circuits are provisioned on it.
the Ethernet duplex value is invalid. Enter
again.
The committed info rate value is invalid.
Enter again.
The mode value is invalid. Enter again.
The MTU value is invalid. Enter again.
The flow control value is invalid. Enter
again.
The network interface mode value is
invalid. Enter again.
The ingress COS value is invalid. Enter
again.
The Ethertype value is invalid. Enter again.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-47

Advertisement

Table of Contents
loading

Table of Contents