Cisco ONS 15454 Troubleshooting Manual page 526

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-5074 Deleting OCH DCN circuits will cause a loss of connectivity to
nodes in the circuit path that do not have other DCN
connections.
Do you want to continue?
EID-5075 The VLAN ID must be a number between 1 and 4093.
EID-5076 An error occurred while provisioning the VLAN ID.
The VLAN ID is already present in the current profile
EID-5077 An error occurred while provisioning the VLAN database
profile.
{0}
EID-5078 The VLAN merge is not complete.
You forgot to fill {0} record(s).
EID-5079 An error occurred while validating the provisionable patchcord. Refer to the error message text.
EID-5080 No rolls are available.
EID-5081 An error occurred while tracing the RPR ring:
{0}
EID-5082 {0} does not support:
- Low-order circuits that have both {1}-protected and
{2}-protected spans and that cross a node that does not have
low-order cross-connect capability.
- High-order circuits that carry low-order circuits with the
parameters described above.
EID-5083 This circuit is not the same size as the existing circuit {0}.
This circuit has size {1} and the existing circuit has size {2}.
EID-5084 The Trunk model could not be found.
{0}
EID-5085 The maximum number of VLAN DB profiles is {0}.
EID-5086 The circuit roll failed.
You cannot bridge and roll the selected circuit because it has a
monitor circuit.
EID-5087 You cannot use same slot for east working and west protect
ports.
EID-5088 You cannot use same slot for east working and west protect
ports.
WID-5089 The maximum number of circuits that can be deleted at a time
is 200.
Do you want to delete the first 200 circuits selected?
EID-5090 This operation cannot be completed.
The selected circuits have different state models;
please select circuits of the same type.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-38
Chapter 4
Description
Refer to the error message.
Enter a number between 1 and 4093.
Select a VLAN ID that is not present in the
current profile.
CTC could not save the VLAN profile to the
file name mentioned.
Fill in the number of records specified and
then proceed.
You cannot delete a roll without selecting a
roll.
The circuit reference is invalid.
Refer to the error message text.
During an RPR circuit creation ML card,
the new circuit size and the existing circuit
size must be the same.
The trunk specified is not found.
Refer to the error message.
Refer to the error message.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text
Refer to the error message text
Error Messages
November 2009