Cisco ONS 15454 Troubleshooting Manual page 502

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2200 CTC has detected a jar file deletion. The jar file was used to
manage one or more nodes. This CTC session will not be able
to manage those nodes and they will appear gray on the network
map. It is recommended that you exit this CTC session and start
a new one.
EID-2202 An intra-node DRI circuit must have two sources.
EID-2203 No member was selected.
EID-2204 The number of circuits must be a positive integer.
EID-2205 The circuit type must be selected.
EID-2206 The profile cannot be autoselected. Please select profile(s) to
store and try again.
EID-2207 You cannot add this span. Either the ring name is too long (that
is, ring name length is greater than {0}) or the endpoints do not
support alphanumeric IDs.
EID-2208 This is an invalid or unsupported JRE.
EID-2209 The user name must be at least {0} characters long.
EID-2210 No package name was selected.
EID-2211 No node was selected for upgrade.
EID-2212 A protected line is not provisionable.
WID-2213 The current type or state of some drops does not allow the new
circuit state of {0} to be applied to them indirectly.
EID-2214 The node is disconnected. Please wait until the node
reconnects.
EID-2215 An error occurred while leaving the {0} page.
EID-2216 An error occurred while entering the {0} page.
EID-2217 Some conditions could not be retrieved from the network view Refer to the error message text.
EID-2218 The bandwidth must be between {0} and {1} percent.
EID-2219 The protection operation failed. An XC loopback was applied
on the cross-connection.
EID-2220 The tunnel status is PARTIAL. CTC is not able to change it.
Please try again later.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-14
Chapter 4
Description
Refer to the error message text.
Intranode circuit must have two sources to
be a dual ring interconnect (DRI).
You must select a member.
The number of circuits cannot be zero or
negative.
You must select a circuit type.
Refer to the error message text.
Reduce the length of the ring name, or
remove the alphanumeric characters from
the end points.
The version of Java Runtime Environment
(JRE) is either invalid or unsupported.
The user name must be at least of the
specified character length.
You must select a package name.
You must select a node for the upgrade.
The protected line cannot be provisioned.
Choose another line.
The circuit state, specified by {0} cannot be
applied to the selected drops.
Refer to the error message text.
There was an error while leaving the
specified page.
There was an error while entering the
specified page.
The bandwidth must be within the specified
parameters.
As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
Refer to the error message text.
Error Messages
November 2009