Cisco ONS 15454 Troubleshooting Manual page 501

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2183 The circuit roll failed.
Bridge and roll is not supported on VCAT circuits.
EID-2184 Spanning Tree Protocol cannot be enabled on some ports
because the ports have been assigned an incompatible list of
VLANs.
You can view the VLAN/Spanning Tree table or reassign the
Ethernet port VLANs.
EID-2185 The VLANs on some ports cannot be assigned because they are
incompatible with the Spanning Tree Protocol.
You can view the VLAN/Spanning Tree table or reassign the
VLANs.
EID-2186 The software download failed on node {0}.
EID-2187 The ring name cannot exceed {0} characters.
Please try again.
EID-2188 The nodes in this ring do not support alphanumeric IDs. Please
use a ring ID between {0} and {1}.
EID-2189 The TL1 keyword "all" cannot be used as the ring name.
Please provide another name.
EID-2190 Adding this span will cause the ring to contain more nodes than
allowed.
EID-2191 The ring name must not be empty.
EID-2192 A valid route cannot be found for the circuit creation request.
EID-2193 A valid route cannot be found for the circuit drop creation
request.
EID-2194 A valid route cannot be found for the roll creation request.
EID-2195 The circuit VLAN list cannot be mapped to one spanning tree.
You can view the VLAN/Spanning Tree table or reassign
VLANs.
EID-2196 CTC cannot be relaunched.
{0}
EID-2197 A CORBA failure occurred. CTC cannot proceed.
EID-2198 CTC is unable to switch to the {0} view.
EID-2199 Login failed on {0} {1}
November 2009
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The software could not be downloaded onto
the specified node.
You must shorten the length of the ring
name.
The ring ID should not contain
alphanumeric characters, and must be in the
specified range.
Refer to the error message text.
You have reached the maximum number of
nodes allowed.
You must supply a ring name.
CTC could not complete the circuit creation
request either because there are no physical
links, or the bandwidth of the available
links are already reserved.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
There is an error relaunching CTC.
There was a CORBA failure, and the task
cannot proceed. Verify the Java version.
CTC is unable to switch to the specified
view.
The login failed on the specified tasks.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-13