Replacing Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Fuji Xerox apeosport-iv C5570 Administrator's Manual

4
Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
5
Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6
Push the staple cartridge into the finisher
until it clicks into place.
7
Close the finisher front cover.
Note • If the front cover is not completely closed, a message will appear and the machine remain

Replacing Staple Cartridge (for Booklet Maker Unit for Finisher-B1)

When the optional Booklet Maker Unit for Finisher-B1 is installed and the staple
cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher side cover.
paused.
performance. Use only staple cartridges recommended by Fuji Xerox.
Replacing Consumables
73
3