Fuji Xerox apeosport-iv C5570 Administrator's Manual page 450

14 Problem Solving
Error Code
C P F S M O
012-210
012-211
012-212
012-213
012-221
012-223
012-224
012-225
012-226
012-227
012-228
012-229
012-230
012-231
012-232
012-233
012-234
012-243
012-246
012-247
012-249
012-254
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
14
Center. The contact number is printed on the label or card attached on the machine.
448
Category
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Completely insert the Booklet Maker into the Finisher, and
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Remove any foreign object under the Center Tray (Right
Cause and Remedy
Finisher malfunction
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
The Booklet Maker is not fully inserted completely into the
Finisher.
turn the machine off and then on.
Finisher malfunction
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
The sensor was activated because the paper being output to
the Finisher was removed before the Center Tray (Right
Middle Tray) lowered completely into position. Or, there is a
foreign object under the Center Tray (Right Middle Tray).
Middle Tray). Switch off the machine power, make sure that
the touch screen is blank, and then switch on the machine
power. If the error still is not resolved, contact our
Customer Support Center.