Data Restoration - Fuji Xerox apeosport-iv C5570 Administrator's Manual

prevents unauthorized access to the stored data. To activate this feature, set an encryption
key.
Note • An optional component is required to use this feature. For more information, contact our
Customer Support Center.
1
Select [Data Encryption].
2
Select [On].
3
Select [New Encryption Key], and enter an
encryption key of 1 to 12 single-byte
characters, and then select [Save].
4
Select [Re-enter Encryption Key].
5
Enter the same encryption key, and then
select [Save].
6
Select [Save].

Data Restoration

The encrypted data cannot be restored in the following cases:
When a problem occurs with the hard disk.
When you have forgotten the encryption key.
When you have forgotten the system administrator's user ID and a passcode when [On] is
selected in [Service Rep. Restricted Operation].
Starting the Data Encryption and Changing Settings
When you select/deselect data encryption or change the encryption key, you must restart the
machine. When the machine reboots, the machine initializes part of the disk area. The
previous data is not secured.
The disk area stores the following data.
- Spooled print data
- Print data including Secure Print and Sample Set
- Forms for the Form Overlay feature
- Folder and job flow sheet settings (folder name, passcode, etc.)
- Files in folders
- Address book data
Important • Be sure to save all necessary settings and files before using data encryption or changing
any settings.
• Make sure that the hard disk and encryption settings match. Otherwise, an error will occur.
For information on error messages and their remedies, refer to "Other Errors" (P.524).
• The following procedure is recommended for changing the encryption settings while a large
amount of data (100 jobs or more) is stored in a folder, and [Number of Overwrites] is set to
[1 Overwrite] or [3 Overwrites] under [Overwrite Hard Disk].
1. Select [Tools] > [Setup] > [Create Folder] to display the [Create Folder] screen.
2. Select the folder, then select [Delete Folder].
3. Select [Close].
4. Press the <Machine Status> button, and confirm that [Standby] in [Overwrite Hard Disk] is
displayed.
5. Enter the System Administration mode, and change the data encryption settings.
For information on how to enter the System Administration mode, refer to "System Settings
Procedure" (P.114).
• Our service representative cannot restore the encryption key.
• When our service representative replaces the electrical circuit board, the encryption key is
initialized. Do not lose the encrypted information.
Common Service Settings
161
5