Table of Contents
Advertisement
14 Problem Solving
Error Code
C P F S M O
033-738
033-740
033-741
033-742
033-743
033-744
033-745
033-746
033-747
033-749
033-750
033-751
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
14
512
Category
O
[Cause]
[Remedy] No measure is required.
O
[Cause]
[Remedy] No measure is required.
O
[Cause]
[Remedy] Execute the operation again. If the error still is not
O
[Cause]
[Remedy] If this error was caused when using Manual Send, connect
O
[Cause]
[Remedy] Switch off the machine power, make sure that the touch
O
[Cause]
[Remedy] No measure is required.
O
[Cause]
[Remedy] No measure is required.
O
[Cause]
[Remedy] Switch off the machine power, make sure that the touch
O
O [Cause]
[Remedy] No measure is required because the machine will output
Cause and Remedy
Received abnormal JBIG data.
The printing of the received fax document was interrupted.
An error occurred during fax transmission.
resolved, contact our Customer Support Center.
An error occurred during fax transmission. This error may
occur if the remaining capacity of the machine's memory is
10% or less and Manual Send is used.
the line after storing the document, and then send. If the
error still is not resolved, delete unnecessary data from the
hard disk to free up disk space, and execute the operation
again.
If the error persists, contact our Customer Support Center.
An error occurred during fax transmission.
screen is blank, and then switch on the machine power.
Try again. If the error still is not resolved, contact our
Customer Support Center.
The job is temporarily suspended.
The machine will automatically recover and print the
document.
An error occurred during fax transmission.
screen is blank, and then switch on the machine power.
Try again. If the error still is not resolved, contact our
Customer Support Center.
An activity report output occurred during the printer lockout
duration. Outputting the activity report was suspended
because the machine was in the Sleep mode.
the report after exiting the Sleep mode.
Advertisement
Chapters
Table of Contents
