Fuji Xerox apeosport-iv C5570 Administrator's Manual page 513

Category
Error Code
C P F S M O
033-722
O
033-724
O
033-725
O
033-726
O
033-727
O
033-728 O
033-731 O
033-733 O
033-734 O
033-735 O
033-736
O
033-737
O
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
[Cause] The document is jammed, or the document pages exceeds
the limit.
[Remedy] Remove the jammed paper or reduce the number of
document pages to the allowable limit, and retry sending.
[Cause] The reception was interrupted because the image volume
exceeded the upper limit.
[Remedy] Install the Extension System Memory to increase the
maximum volume of image data.
[Cause] The hard disk is full.
[Remedy] Delete unnecessary data from the hard disk to free up disk
space.
[Cause] The received document was printed with 1 sided printing,
because 2 sided printing is not available for mixed sized
documents.
[Remedy] No measure is required.
[Cause] The received page was printed without being rotated,
because its data volume was too large to change the
orientation automatically.
[Remedy] No measure is required.
[Cause] The auto print formatting of the received fax document
was interrupted by a manual print operation.
[Remedy] No measure is required. The machine will automatically
start the auto print job after manual printing completes.
[Cause] The printing of the received fax document was interrupted.
[Remedy] The auto print processing of the received fax document
was interrupted by a manual print operation. No measure
is required.
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
[Cause] Because a report job was instructed while preparing to
print a received fax, the printing of the received fax is
temporarily suspended.
[Remedy] No measure is required.
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
[Cause] The forwarding job was interrupted because the data
volume exceeded the upper limit.
[Remedy] No measure is required.
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not
resolved, contact our Customer Support Center.
Error Code
14
511