Fuji Xerox apeosport-iv C5570 Administrator's Manual page 187

Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server 2003, or Windows
Server 2008 as server, specify the domain name of Active Directory in [Domain Name]. Up to
64 characters are allowed.
Important • Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
LDAP Server/Directory Service Settings (ApeosPort Series Models Only)
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value 0
to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
Secondary Server - Port Number
Set the secondary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
Authentication Method
Select a method to perform LDAP authentication from [Direct Authentication] and
[Authentication of User Attributes].
Connectivity & Network Setup
185
5