Fuji Xerox apeosport-iv C5570 Administrator's Manual page 409

Symptom
The copy is Is the document loaded
misaligned or correctly?
skewed.
Is the paper loaded correctly
in the tray?
Are the paper guides of
Tray 5 correctly aligned to
the paper?
Are the document guides on
the document feeder set in
the correct positions?
Is the paper tray inserted
correctly?
Part of the image Is the paper damp?
is missing on the
copy.
Is folded or wrinkled paper
included in the tray?
Is the document pasted or
folded?
The copy has a Is the enlargement ratio too
stripe pattern. large?
Color shift of Is the color calibration
color copies is incorrect?
poor, resulting in
Is the machine set where it
unsatisfactory
is exposed to direct
image quality.
sunlight?
Cause
Load the document correctly.
Refer to "3 Copy" > "Copying Procedure" in
the User Guide.
Load the paper correctly.
Refer to "Loading Paper" (P.43).
Load the paper correctly and align the
document guides to the document edges.
Refer to "Loading Paper in Tray 5" (P.46).
Load the document correctly, and align the
document guides to the document edges.
Refer to "3 Copy" > "Copying Procedure" in
the User Guide.
Firmly push in the tray until it stops to
insert it properly.
Refer to "Loading Paper" (P.43).
If the paper is damp, the copy image may
be partially missing or unclear. Replace the
paper with new one.
Refer to "Loading Paper" (P.43).
Remove the unsuitable paper or replace all
of the paper with new one.
Refer to "Loading Paper" (P.43).
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the
document to flatten the document against
the document glass.
Vertical stripes may be printed on the
copies depending on the ratio. Adjust the
ratio to eliminate the stripes.
Refer to "3 Copy" > "Copy" > "Reduce/Enlarge
(Making Enlarged/Reduced Copies)" in the
User Guide.
Execute auto calibration.
Refer to "Executing Calibration" (P.85).
If the document glass is exposed to strong
light when you turn the machine on or
cancel the Energy Saver mode, color shift
may occur. Close the document cover and
turn the machine on, and when the
machine becomes ready to copy or print,
turn the machine off and then on one more
time.
Image Quality Trouble
Remedy
407
14