Hp-Gl/2 Emulation Settings - Fuji Xerox apeosport-iv C5570 Administrator's Manual

15 Appendix
Paper Margin
The paper size is set to A4 by factory default. If the print data is larger than the active
coordinates area, the machine prints the data on the next larger A series paper (in this
case, A3).
When you set the paper margins, however, the active coordinates area is determined
by subtracting the area set in paper margins from the active coordinates area obtained
in the area determination mode. Therefore, set the paper margins if the data is printed
on larger paper than specified. Set the range from 0 to 99 mm. The default value is 0
mm.

HP-GL/2 Emulation Settings

The following table shows the emulation parameters and their values for HP-GL2
emulation.
HP-GL Settings List
Items that can be set using the HP-GL mode menu are explained in two groups: basic
settings and extended settings.
Basic Settings
Parameter
Document size
15
606
Item No.
101 Sets the document size created by a computer.
[0]
[1]
[2]
[3]
[4]
[5]
[10]
[11]
[12]
[13]
[14]
[15]
[99] (Default)
[100]
When [Auto] is selected, the settings of the Scaling mode, the Area
Determination mode, and the Paper Margin settings of Print Control
become enabled.
Note • If the document size other than [Auto] is selected, the settings under
[Auto layout] become [ON].
• Depending on the combination of [Document size] and [Paper size],
the document is printed at a scale of 100%.
Value
: A0
: A1
: A2
: A3
: A4
: A5
: B0
: B1
: B2
: B3
: B4
: B5
: Auto
: Paper