Fuji Xerox apeosport-iv C5570 Administrator's Manual page 474

14 Problem Solving
Error Code
C P F S M O
017-701
017-702
017-703
017-704
017-705
017-706
017-707
017-708
017-709
017-713
017-714
017-715
017-716
14
017-717
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
472
Category
O [Cause]
[Remedy] Confirm the connection to the ThinPrint.Engine.
O [Cause]
[Remedy] Confirm the connection to the ThinPrint.Engine.
O [Cause]
[Remedy] Split the job, and try printing again.
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Check the server certificate information (expiry date and
O [Cause]
[Remedy] Check the settings of the machine.
O [Cause]
[Remedy] Change SSL/TLS communication setting to other than
O [Cause]
[Remedy] Confirm whether the SMTP server supports SSL
O [Cause]
[Remedy] Use the valid SSL server certificate of the SMTP server.
O [Cause]
[Remedy] Use the valid SSL server certificate of the SMTP server.
O [Cause]
[Remedy] Use the valid SSL server certificate of the SMTP server.
Cause and Remedy
An error occurred while connecting to ThinPrint.Engine.
The data sent to ThinPrint.Engine is invalid.
The print data sent from ThinPrint.Engine exceeded the
maximum size of the machine.
An internal error occurred.
screen is blank, and then switch on the machine power.
Send the job again.
ThinPrint.Engine SSL authentication error.
address) that is registered to ThinPrint.Engine.
An SSL communication error occurred between
ThinPrint.Engine and the machine.
The SMTP server does not support STARTTLS.
[STARTTLS].
SSL connection to the SMTP server failed.
connection. If the server supports it, check the port
number of the SMTP server. If the error still is not
resolved, contact our Customer Support Center.
SMTP server SSL server authentication error. The server
certificate is invalid.
You can avoid this error by setting [SMTP-SSL/TLS
Communication] in [SSL/TLS Settings] to [Disabled],
however the validity of the server cannot be warranted.
SMTP server SSL server authentication error. It is before
the valid period of the server certificate.
You can avoid this error by setting [SMTP-SSL/TLS
Communication] in [SSL/TLS Settings] to [Disabled],
however the validity of the server cannot be warranted.
SMTP server SSL server authentication error. The server
certificate expired.
You can avoid this error by setting[SMTP-SSL/TLS
Communication] in [SSL/TLS Settings] to [Disabled],
however the validity of the server cannot be warranted.