Interface Modules (Im) - Siemens SIMATIC PCS 7 Configuration

1 Introduction
1.3 Hardware components
1.3.2

Interface modules (IM)

Interface modules (IM) are used by the distributed I/O device ET 200M as
a PROFIBUS DP interface. With redundant peripherals, one must ensure that
two interface modules (IMs) are used per ET 200M station and that the same bus
address is set for both modules (via dip switches).
This ensures that if the active interface module fails during operation, the passive
interface module takes over the corresponding function smoothly. The active
interface is indicated by the lit ACT LED on the respective interface module.
Table 1–2: IM module for redundant applications
Name
ET 200M - IM 153-2
ET 200M - IM 153-2
ET 200M - IM 153-2
Configuration of Redundant I/O Modules
Entry-ID: 28430682, V2.0,
MLFB
6ES7 153-2BA02-0XB0
V5.x
6ES7 153-2BA82-0XB0
V5.x
6ES7 153-2BA70-0XB0
03/2015
Product Brief
Bus interface for S7-300 SMs, FMs
(without FM 356-4),
module exchange during operation,
expansion of the instrumentation and
control functions, up to 12 I/O modules
can be operated
Bus interface for S7-300 SMs
(outdoor),
FMs (without FM 356-4),
module exchange during operation,
expansion of the instrumentation and
control functions, up to 12 I/O modules
can be operated
Bus interface for S7-300 SMs
(outdoor); FMs (without FM 356-4),
module exchange during operation, up
to 12 I/O modules can be operated
9