To Remove And Replace The Front Panel Assembly - Agilent Technologies 16901A Service Manual

To remove and replace the front panel assembly

16901A Logic Analysis System Service Guide
1 Perform previous procedures:
• "To prepare the instrument for disassembly"
page 46.
• "To remove and replace the cover"
Disconnect the following cables:
2
• USB cables from the motherboard.
• Display cable from the display board (use care when
disconnecting to avoid damage).
• Touch screen cable from the touch screen controller
board.
• Keyboard cable from the keypad board.
• Front panel cable from the backlight inverter board.
Using a Torx T10 screwdriver, remove 4 screws that
3
secure the shroud to the chassis.
4 Remove the shroud.
Replacing Assemblies
on
on page 50.
Shroud
T-10
screws (4)
6
57