Setting Interval Wiping; Setting External Heater; Setting For Improving Image Quality By Changing Media-Feeding Rate (Belt Comp.); Setting Belt Wash - MIMAKI Tx300P-1800B Operation Manual

Setting Interval wiping

When the set time has passed, nozzle face of the head is
cleaned automatically to remove ink droplets on the
nozzle face.
In case that deflection, nozzle missing, or symptom which
ink droplets fall down occurred, set the interval between
each operation shorter.
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "INTERVAL
4
WIPING", and press the
Press to set intervals.
5
• Set Value : 3 to 255 Minutes, OFF
• When [OFF] is set, periodical wiping is not
executed.
Press the
6
Press the
7
end the setting.

Setting External heater

Used to set external heater to ON/OFF.
Press (MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "EXTERNAL
4
HEATER", and press the
Press to select set value.
5
• Set Value: ON/OFF
Press the
6
Press the
7
end the setting.
in LOCAL.
key.
key.
key.
key several times to
in LOCAL.
key.
key.
key.
key several times to
Setting for Improving Image Quality by
Changing Media-feeding Rate (BELT COMP.)
Setting the BELT COMP. to ON allows for improved print
quality.
Set belt comp. to ON at times when you are concerned
about unevenness during printing or seam joint of the belt.
• When you change setting of the belt correction,
set the feeding correction. (
Press (MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "BELT COMP.",
4
and press the
Press to select set value.
5
• Set Value: ON/OFF
Press the
6
Press the
7
end the setting.

Setting Belt Wash

Using the belt wash feature makes it possible to remove
ink stains which go through the media and appear on the
feeding belt.
• The belt wash function only activates during
feeding belt operation.
• The best wash function will not operate, even
when set to ON, if the feeding belt is not in
operation.
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "BELT WASH",
4
and press the
Press to select set value.
5
• Set Value: ON/OFF
• Because the absorb roller may be deformed, when
setting in "OFF", make sure to remove it in
advance. ( P.4-22)
Chapter 3 Setup
P.2-27)
in LOCAL.
key.
key.
key.
key several times to
in LOCAL.
key.
key.
3-11
1
2
3
4
5
6