Connecting The Power Cable - MIMAKI JV300-130 Installation Manual

INSTALLATION GUIDE > Power Supply Related > Connecting the Power Cable
Issue
Model
JV300

6.2 Connecting the Power Cable

 Outline
This device connects to the included power cable.
If you do not use the included power cables, use cable that match your region.
Connect the power cables into a power outlet with the following specifications.
Voltage AC100 - 120V / 220 - 240V
Frequency 50/60Hz
AC100 - 120V: 1440W
Capacity
AC220 - 240V: 1920W
 Always connect the cables to a power outlet near the device so that the cables can be easily removed.
 When plugging the cables into the power outlets, connect the cable into outlets on a separate circuit
from other devices. Because of the large power consumption, the power supply breaker may be
tripped.
 Power supply cables should be connected to an earthed outlet. Otherwise, there is a risk of electrical
shock or of damaging the device.
 When connecting the power cables, ensure that the power switch of the device is off.
© 2014 MIMAKI ENGINEERING CO.,LTD.
Revised 2014.05.08 F/W ver. 1.00 Remark
2014.04.11
1. Insert the power cable clamp into the power supply box.
Power cable
clamp
2. Insert the power cable into the inlet of this device.
3. Lock the power cable.
4. Insert the power plug into a plug socket.
300 model : Power cable x 2
Run the power cable through the clamp, and lock the clamp
until it clicks.
Rev.
1.1
1
2
3
4
5
6
7
6.2 R.1.1 P.3