Connecting The Power Cable; Turning On The Power - MIMAKI JV330 Series Operation Manual

Chapter 1 Before Use

1.2 Connecting the Power Cable

1
Check to confirm that the main power supply is turned off.
2
Insert the cable band to the machine.
3
Plug the power cable into the inlet of the machine.
4
Secure the power cable to the cable band.
• Pass the power cable through the clamp and clamp until it clicks into place.
5
Plug the power plug into the power outlet.
• Do not handle the power plug with wet hands. There is a risk of electric shock.

Turning On the Power

• Close the front cover and maintenance covers. Leaving any of the covers open will disable the
automatic maintenance function (including nozzle clogging prevention function and ink
discharge channel cleaning function). This will increase the risk of failure or printing defects
(e.g., nozzle clogging or deflection).
1
Check to confirm that the main power supply is turned on.
• If the main power supply switch is not turned on, set to "I".
[JV/CJV]
Cable band
Power plug
Heater power supply switch
34
Power cable
Power outlet
[TS]