Setting The Parameters Of Igmp Features; Establishing The Configuration Task - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Run the display igmp group static command to check the information about the static IGMP
multicast group.
<Quidway> display igmp group static
Static join group information
Total 2 entries, Total 2 active entries
Group Address
225.0.0.10
232.1.1.20

5.4 Setting the Parameters of IGMP Features

This section describes how to set the parameters of IGMP features.
Context
By default, IGMP can work normally. In the S3700, you can change the values of related
parameters according to the specific network environment. You can perform the following
configurations as required.

5.4.1 Establishing the Configuration Task

Applicable Environment
IGMPv2 and IGMPv3 have the Group-Specific and Source/Group-Specific Query messages.
The groups are varied and an S3700 cannot join all groups. Therefore, the IGMP needs to use
the Router-Alert option. Then the IGMP can send messages for the groups that the local device
does not join to the upper protocol for processing.
The IGMP querier periodically sends IGMP Query messages on the shared network connected
to receivers. When receiving a Report message from a member, the querier updates information
about the membership. If non-queriers do not receive any General Query message within the
Keepalive period of the IGMP querier, the querier is considered faulty, and a new round of the
querier election is triggered automatically.
In some cases, one host matches a port. Therefore, a querier matches only one receiver host.
When a receiver host switches between multiple groups frequently, you can enable the prompt
leave mechanism on the querier.
Issue 01 (2011-10-26)
IGMP state: up
IGMP group policy: none
IGMP limit: -
Value of query interval for IGMP (negotiated): -
Value of query interval for IGMP (configured): 60 s
Value of other querier timeout for IGMP: -
Value of maximum query response time for IGMP: 10 s
Querier for IGMP: 100.0.0.3 (this router)
Source Address
0.0.0.0
10.0.0.1
NOTE
l The configuration in the IGMP view is valid globally. The configuration in the interface view is valid
only for the specific interface.
l If this command is configured in the interface view and the IGMP view, the values set in the interface
view are preferred. If this command is not configured in the interface view, the values configured in
the IGMP view are valid.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Interface Expires
Loop1 never
Vlanif3 never
5 IGMP Configuration
75