Optional) Adding An Interface To A Multicast Group Statically; Optional) Configuring An Interface As A Static Router Interface - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
MLD snooping is enabled in the VLAN.
When MLD snooping is disabled in a VLAN by default.
----End
10.3.4 (Optional) Adding an Interface to a Multicast Group
Statically
Context
To add an interface to a multicast group statically, do as follows on the S3700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the following commands as required:
l Run:
Step 3 Run:
mld-snooping static-group
vlan vlan-id }
The interface is added to a multicast group statically.
----End
10.3.5 (Optional) Configuring an Interface as a Static Router
Interface
Context
To configure an interface as a static router interface, do as follows on the S3700.
Procedure
Step 1 Run:
system-view
Issue 01 (2011-10-26)
interface interface-type interface-number
The interface view is displayed.
The interface can be an Ethernet interface, a GE interface or an Eth-Trunk interface.
NOTE
l Before using the mld-snooping static-group command, ensure that the interface is added to the VLAN
specified by vlan-id; otherwise, the configuration fails.
l If the source-address parameter is specified in the mld-snooping static-group command, the MLD
version must be V2; otherwise, the configuration does not take effect even though the command can
be run.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
{ group-ipv6-address [ source source-ipv6-address ]
10 MLD Snooping Configuration
259