Managing Msdp Peer Connections; Establishing The Configuration Task - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
<Quidway> display msdp brief
MSDP Peer Brief Information
Configured
1
Peer's Address
2.2.2.2
Run the display pim routing-table command. If the RP information corresponding to the
routing table is displayed, it means that the configuration succeeds. For example:
<Quidway> display pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(10.11.1.2, 225.1.1.1)

8.5 Managing MSDP Peer Connections

MSDP peers should set up TCP connections. You can then flexibly control the sessions set up
between MSDP peers by closing or re-establishing TCP connections. You can also adjust the
interval for retrying to set up a TCP connection between MSDP peers.

8.5.1 Establishing the Configuration Task

After PIM-SM inter-domain multicast or anycast RP in a PIM-SM domain is configured, you
can manage the connection between MSDP peers as required.
Applicable Environment
MSDP peers are connected by the TCP connection (the port number is 639). Users can close or
reestablish a TCP connection, and flexibly
When a new MSDP peer is created, or when a closed MSDP peer connection is restarted, or
when a faulty MSDP peer tries recovering, the TCP connection needs to be immediately set up
between MSDP peers. Users can flexibly
peer
Pre-configuration Tasks
Before managing MSDP peer connections, complete the following tasks:
l
l
l
l
Data Preparation
To manage MSDP peer connections, you need the following data.
Issue 01 (2011-10-26)
Up
1
State
UP
RP: 7.7.7.7 (local)
Protocol: pim-sm, Flag: SPT ACT
UpTime: 00:01:57
Upstream interface: Vlanif10
Upstream neighbor: 10.3.1.2
RPF prime neighbor: 10.3.1.2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlanif20
Protocol: pim-sm, UpTime:
connection.
Configuring a unicast routing protocol to implement interconnection at the network layer
Enabling IP multicast
Configuring a PIM-SM domain to implement intra-domain multicast
Configuring PIM-SM Inter-domain Multicast
PIM-SM Domain
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Listen Connect
0 0
Up/Down time AS
00:10:17 ?
- , Expires:
control the sessions set up between MSDP
adjust the interval for retrying setting up an MSDP
or
8 MSDP Configuration
Shutdown Down
0 0
SA Count Reset Count
0 0
-
Configuring an Anycast RP in a
peers.
206