Checking The Configuration; Adjusting Control Parameters Of The C-Rp And C-Bsr - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Context
Do as follows on the switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
source-policy acl-number
A filter is configured.
If the basic ACL is configured, only the packets with the source addresses that pass the filtering
are forwarded.
If the advanced ACL is configured, only the packets with the source addresses and group
addresses that pass the filtering are forwarded.
----End

7.4.4 Checking the Configuration

After the control parameters of a multicast source are adjusted, you can run commands to check
entries in the PIM routing table.
Procedure
l
----End

7.5 Adjusting Control Parameters of the C-RP and C-BSR

If a dynamic RP is used, you can adjust parameters of C-RPs and C-BSR as required. If there is
no special requirement, default values are recommended.
Issue 01 (2011-10-26)
Run the following commands to check the PIM routing table.
– display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-
interface { interface-type interface-number | register } | outgoing-interface
{ include | exclude | match } { interface-type interface-number | register | none } |
mode { dm | sm | ssm } | flags flag-value | fsm ]
[ number ] ]
– display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-
interface { interface-type interface-number | register } ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
*
[ outgoing-interface-number
*
147