Configuring The Interval For Sending State-Refresh Messages - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Context
Do as follows on all the switchs in the PIM-DM domain.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
undo pim state-refresh-capable
PIM-DM State-Refresh is disabled.
The interface on which PIM-DM State-Refresh is disabled cannot forward any State-Refresh
message.
----End

6.7.3 Configuring the Interval for Sending State-Refresh Messages

To prevent pruned interfaces from forwarding messages after the prune state timer times out,
you need to set the interval for sending State-Refresh messages to be shorter than the period for
keeping the Prune state.
Context
Do as follows on all the switchs in the PIM-DM domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
Issue 01 (2011-10-26)
NOTE
By default, PIM-DM State-Refresh is enabled on the interface.
NOTE
You can run the pim state-refresh-capable command to re-enable PIM-DM State-Refresh on the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-DM (IPv4) Configuration
117