Checking The Configuration; Maintaining Pim-Sm (Ipv4); Clearing Statistics Of Pim Control Messages - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed
The interface must be a VLANIF interface.
Step 3 Run:
pim bfd { min-tx-interval tx-value | min-rx-interval rx-value | detect-multiplier
multiplier-value }*
PIM BFD parameters are adjusted.
PIM BFD parameters include the minimum interval for sending PIM BFD messages, the
minimum interval for receiving PIM BFD messages, and the local detection multiple.
If this command is not used, the default values of these parameters are used. When the BFD
parameters configured for other protocols are the same as those configured for PIM, the
configurations of the PIM BFD parameters are affected.
----End

7.12.4 Checking the Configuration

After PIM BFD is configured, you can run the command to check information about PIM BFD
sessions.
Procedure
l
----End

7.13 Maintaining PIM-SM (IPv4)

Maintaining PIM-SM involves resetting PIM statistics, and monitoring PIM running status.

7.13.1 Clearing Statistics of PIM Control Messages

If you need to re-collect the statistics about PIM control messages, you can reset the existent
statistics. Note that the statistics cannot be restored after you reset them. This operation does not
affect normal running of PIM.
Issue 01 (2011-10-26)
Run the following commands to check information about a PIM BFD session.
– display pim bfd session statistics
– display pim bfd session [ interface interface-type interface-number | neighbor
neighbor-address ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
7 PIM-SM (IPv4) Configuration
177