Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
l group-address { mask | mask-length }: specifies the group address and mask.
l source-address: specifies the address of the source mapping the SSM group.
----End
5.5.4 Checking the Configuration
Prerequisite
The configuration of SSM mapping is complete.
Procedure
l
l
----End
Example
Run the display igmp ssm-mapping group [ group-address ] command, and you can view the
information about SSM mapping of a specified group address.
<Quidway> display igmp ssm-mapping group 232.0.0.1
IGMP SSM-Mapping conversion table
Total 2 entries
00001. (10.0.0.1, 232.0.0.1)
00002. (10.0.0.2, 232.0.0.1)
Total 2 entries matched
Run the display igmp ssm-mapping interface interface-type interface-number command, and
you can view information about SSM mapping on a specified interface.
<Quidway> display igmp ssm-mapping interface vlanif 3
Info: IGMP SSM-Mapping is enabled
5.6 Maintaining IGMP
This section describes how to maintain IGMP.
5.6.1 Clearing the Information About an IGMP Group
Issue 01 (2011-10-26)
Run the display igmp group [ group-address | interface interface-type interface-
*
number ]
ssm-mapping [ verbose ] command to check the address of a specific source or
group.
Run the display igmp ssm-mapping { group [ group-address ] | interface [ interface-
type interface-number ] } command to check the information about SSM mapping of a
specific source or group.
2 entries matched
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 IGMP Configuration
85