Checking The Configuration; Adjusting Control Parameters For Prune; Establishing The Configuration Task - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Context
To prevent some switch from being involved in PIM, filtering PIM neighbors is required.
Do as follows on the switch running PIM-DM:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
pim neighbor-policy basic-acl-number
PIM neighbor filtering is configured.
----End

6.5.6 Checking the Configuration

After the neighbor control parameters are adjusted, you can run commands to check information
about the PIM interface and the PIM neighbor.
Procedure
l
l
----End

6.6 Adjusting Control Parameters for Prune

When the last member leaves a group, the multicast device sends a Prune message upstream,
requesting the upstream device to execute the prune action. If other downstream devices on the
same network segment need the multicast data for this group, they need to send Join messages
to override the prune action.

6.6.1 Establishing the Configuration Task

After basic PIM-DM functions are configured, you can set the period for an interface to keep
the prune state, delay for transmitting Prune messages in a LAN, and interval for overriding the
prune action as required.
Issue 01 (2011-10-26)
Run the display pim interface [ interface-type interface-number | up | down ]
[ verbose ] command to check PIM on an interface.
Run the display pim neighbor [ neighbor-address | interface interface-type interface-
*
number | verbose ] command to check information about a PIM neighbor.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-DM (IPv4) Configuration
111