Configuring Multicast Vlan Replication Based On User Vlans - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Pre-configuration Tasks
Before configuring multicast VLAN replication based on user VLANs, complete the following
tasks:
l
l
Data Preparation
To configure multicast VLAN replication based on user VLANs, you need the following data.
No.
1
2
3
3.3.2 Configuring Multicast VLAN Replication Based on User
VLANs
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Step 3 Run:
igmp-snooping enable
IGMP snooping is enabled in the VLAN.
Step 4 Run:
multicast-vlan enable
Multicast VLAN replication is enabled, and the VLAN is configured as a multicast VLAN.
By default, multicast VLAN replication is disabled.
After IP multicast is configured on the S3700, no multicast VLAN can be configured.
Step 5 Run:
multicast-vlan user-vlan { { vlan-id1 [ to vlan-id2 ] } & <1-10> }
User VLANs are bound to the multicast VLAN.
Issue 01 (2011-10-26)
Connecting interfaces and setting physical parameters for the interfaces to ensure that the
physical status of the interfaces is Up
Enabling IGMP snooping globally
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Multicast VLAN Replication Configuration
Data
Multicast VLAN ID
User VLAN IDs
Types and numbers of interfaces
40