Configuring The Interval For Sending Hello Messages - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
No.
1
2
3
4

6.5.2 Configuring the Interval for Sending Hello Messages

The interval for sending Hello messages can be set either globally or on an interface. The
configuration in the interface view is prior to the configuration in the PIM view. When the
interval is not configured in the interface view, the configuration in the PIM view takes effect.
Context
Do as follows on the PIM-DM switch:
Procedure
l
l
Issue 01 (2011-10-26)
Data
Timeout period of the neighbor
Interval for sending Hello messages
Maximum delay for triggering Hello messages
Number or name of the ACL used to filter PIM neighbors
NOTE
The configuration involves the following cases:
l Global configuration: It is valid on each interface.
l Configuration on an interface: The configuration on an interface takes precedence over the global
configuration. If the configuration on an interface is not done, the global configuration is used.
Global Configuration
1. Run:
system-view
The system view is displayed.
2. Run:
pim
The PIM view is displayed.
3. Run:
timer hello interval
The interval for sending Hello messages is set.
Configuration on an Interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-DM (IPv4) Configuration
108