Configuring A Multicast Group; Configuring A Multicast Group List - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
No.
1
2
3
4

4.3.2 Configuring a Multicast Group

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
btv
The BTV view is displayed.
Step 3 Run:
multicast-group group-name { ip-address multicast-group-address [ source ipv4-
source-address ] | ipv6-address mld-group-address [ source ipv6-source-address ] }
A multicast group is configured.
By default, no multicast group is configured on the S3700.
----End

4.3.3 Configuring a Multicast Group List

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
btv
Issue 01 (2011-10-26)
Data
Name and IP address of a multicast group
Name of a multicast list
Name of a multicast profile
IDs of the user VLANs that apply multicast profiles
NOTE
If the interface connected to the user device is configured IGMPv2, you do not need to specify the
source ipv4-source-address parameter; if the interface is configured with IGMPv3, you must specify
source ipv4-source-address.
If the configured multicast groups have the same address, you can use the group-name parameter to change
the names of multicast groups.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Controllable Multicast Configuration
61