Enabling Pim-Dm; Checking The Configuration - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast routing-enable
IPv4 multicast routing is enabled in the public network.
----End

6.3.3 Enabling PIM-DM

An interface can set up PIM neighbor relationship with other devices after PIM-DM is enabled
on it.
Context
Do as follows on the switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
pim dm
PIM-DM is enabled.
After PIM-DM is enabled on the interface and the PIM neighbor relationship is set up between
switches, the protocol packets sent by the PIM neighbors can be processed. You can run the
undo pim dm command to disable PIM-DM on the interface.
----End

6.3.4 Checking the Configuration

After PIM-DM is configured successfully, you can check information about the PIM interface,
PIM neighbor, and PIM routing table through commands..
Issue 01 (2011-10-26)
NOTE
When switchs are distributed in different PIM-DM domains, enable PIM-SM on all non-boundary
interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-DM (IPv4) Configuration
103